The power supply will be controlled via a Touch pad interface which will be mounted onto a NEMA 2 remote enclosure.  The Touch pad Interface will have the following features:

·         Digital 4 Digit Display of DC Volts and DC Amperes

·         Precision Voltage and Current Pushbuttons with Setpoint Displays

·         Start, Stop, Reset, Manual/Auto and Polarity (+/-) Pushbuttons

·         Alphanumeric display with backlight for status indication, setup and special operating modes

·         Ramp Setpoint Adjust and run display

·         Ramp in voltage or current modes

·         Ramp to a setpoint

·         Cycle Setpoint adjust and run display

·         Selectable time base of milliseconds, seconds, minutes or hours

·         End of Cycle Alarm

·         Amp-Hour Setpoint and run display

·         Totalizer with 8 digit resolution

·         End of Cycle Alarm

·         Program (Profile) Setpoint adjust and run display

·         Twelve (12) Multi-Step profiles with up to 8 steps per program

·         Selectable time base of milliseconds, seconds, minutes or hours

·         Time resolution of 00.0 Sec/Min/Hr

·         Start/Stop Buttons

·         "Power On" Indicator

·         Setpoints and program parameters are automatically restored upon power-up

·         Automatic/Manual Button

·         RS232/485 Interface with ASCII based serial protocol

Precision Voltage and Current Control with Setpoint Displays

Manual/Automatic Mode Operations

Ramp and Cycle Timer

Pulse

Fault Annuciation

NEMA 4X Sealed Stainless Steel Cabinet to protect from hard chemically corrosive environments